Limited warranty – PowerMadd Star Series 14250 Mounting Kit - Snow User Manual

Page 2

HAND GUARD MOUNTING

STEP 6: The 4 pictures below show the options for mounting the hand guard to the bracket.
These options allow you to move the guard right or left depending on the position you prefer.
Hold the hand guards up to the mounted brackets to decide which mounting option to use. Then
follow the instructions below for the option you have chosen.

When mounting the handguard to the bracket, make sure the no-spin spacer is positioned so that
the pin goes into the back hole of the bracket and the bolt goes through the front hole. Also
make sure the no-spin spacer is positioned so that its tabs go over one of the handguard tabs as
in the Option photos below.

Option

IN14250

1-800-435-6881

www.powermadd.com

Option 1 & 2 - RECOMMENDED: The strongest mounting option is to have the bracket and
no-spin spacer inside the handguard tabs. Thread the M6 x 45mm hex head bolt through the
handguard tab, the no-spin spacer and bracket, and then the other tab. Thread the lock nut onto
the bolt and tighten using 10mm wrenches.

Option 3 & 4: Position the no-spin spacer on the bracket and handguard tab. Thread the M6 x
65mm hex head bolt through the bracket, no-spin spacer and handguard tab. Insert the long
spacer in between the handguard tabs and continue to thread the bolt through the long spacer
and the other handguard tab. Thread the lock nut onto the bolt and tighten using 10mm
wrenches.

STEP 7: Adjust both handguards to the desired up/down position by spinning the bracket on
the handlebar. Once in position, use a 10mm wrench to tighten the M6 x 25mm hex head bolt
both brackets. DO NOT over tighten the mounts, you want them tight enough that they won’t
move if you land hard or hit a big bump, but you don’t want them too tight that they won’t
rotate if you were to crash.

STEP 8: All fasteners may need to be retightened after the first ride. Check the tightness
of the bracket and guard before each ride.

LIMITED WARRANTY

POWERMADD warrants this product to be free from defects in material and workmanship under use for the
purpose it was intended. POWERMADD shall not be liable for damage or injury caused by defective materials
or workmanship. POWERMADD may elect to repair or replace this product, but is the sole judge of any
defects in their product. This warranty does not cover any labor costs to remove or reinstall this product and is
effect for one year from the original purchase date.