Bosch DWK09M720 Polar Weiß Wandesse 90 cm Schräg-Essen-Design - Manual (Page 29)

29
• For exhaust-air mode only: Carry out the
connection of one tube (10A – tube and
ties for fastening not included, they need
to be bought) for the fume discharge to
the connection ring placed on top of the
extractor motor unit.
The other end of the tube should be
connected to a fume expulsion device
towards the outside, in case the hood is
used in extractor version.
Note: a multi-fitting for pipes of different
diameters is supplied with the hood (see
drawing below).
Ш 120-125
Ш 150
10A
Installation
• For chimney installation only: In case
you want to use the hood in filtering
version, fasten the deflector F to the
support bracket, and connect the other
side of the tube to the connection ring
placed on the deflector (10F).
10F
G
F
Ø 2,9 x 6,5mm
Use a small flat-tip screwdriver to bend
upwards (perfectly vertical) the three
tangs situated on the upper side of the
hood at the sides of its exhaust hole (11).
They will be used as a stop for the
chimney.
Cover the holes using the adhesive labels
supplied.
11