Bosch DWK09M720 Polar Weiß Wandesse 90 cm Schräg-Essen-Design - Manual (Page 26)

26
Prior to installation
Circulating-air mode
❑ With activated
carbon filter if
exhaust-air mode is
not possible.
The complete installation set can be
obtained from specialist outlets.
The corresponding accessory numbers can
be found at the end of these operating
instructions.
Preparing the wall
❑ The wall must be flat and perpendicular.
❑ Ensure that the wall is capable of
providing a firm hold for mounting screws
and plugs.
Weight in kg:
We reserve the right to construction changes
within the context of technical development.
Electrical connection
The mains power supply must correspond to
the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in an
accessible area. If it not fitted with a plug
(direct mains connection) or if the plug is not
located in an accessible area apply a bi-
polar switch in accordance with standards
which assures the complete disconnection of
the mains under conditions relating to over-
current category III, in accordance with
installation instructions.
Warning: Before re-connecting the hood
circuit to the mains supply and checking the
efficient function, always check that the
mains cable is correctly assembled.
Exhaust-air
mode
Circulating-air
mode
26,8 27
237,4
247,2
180
580
137-565
900
1058,5 - 1486,5
547-975