Bosch Dampfbügeleisen Sensixx´x DA70 i-Temp TDA703021I anthrazit magic violet - Manual (Page 16)

16
EN
G
LI
SH
5
Ironing with steam
Temperature
setting
Recomended steam
regulator setting
●● 1 or 2 / eco*
●●● to max 1 to “max”
i-Temp* 1 to “max”
AntiShine* 1 or 2 / eco*
* model dependent
Tip: for better ironing results, iron the last strokes
without steam to dry the garment.
6
Spray
Do not use the spray function with silk.
7
Shot of steam
• Set temperature to “max”.
• Press button repeatedly with intervals of at
least 5 seconds.
8
Vertical steam
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
• Set temperature to “max”.
• Hang article of clothing on a clothes hanger.
• Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the
button repeatedly with pauses of at least 5
seconds.
9
Multiple descaling
system
This range is equipped with the following
anti-calc systems “3AntiCalc” (components
1+2+3)
1. self-clean
Each time you use the steam regulator, the
“self-clean” system cleans the mechanism of
scale deposits.
2. Calc’nClean
The “Calc’nClean” function helps to remove scale
particles out of the steam chamber. Use this
function approximately every 2 weeks, if the
water in your area is very hard.
1. Unplug the iron from the mains socket, set the
steam regulator to the position and ill the
water tank with water.
2. Set the temperature selector to the “max”
position and plug in the iron.
3. After the necessary warm-up period, the
lamp goes out. Then, unplug the iron (very
important!).
4. Hold the iron over a sink. Press the “clean”
button and shake the iron until approximately
one third of the water capacity of the tank is
evaporated. Boiling water and steam will come
out, carrying scale or deposits that might be
there.
5. Release the “clean” button, and gently shake
the iron for some seconds,
6. Repeat the steps 4 and 5 three times until
the tank is empty. Then plug the iron in and
heat it up again until the remaining water has
evaporated.
7. Unplug the iron and let the soleplate cool down.
Wipe the soleplate with a damp cotton cloth only.
3. anti-calc
The “anti-calc” cartridge has been designed to
reduce the build-up of scale produced during
steam ironing, helping to extend the useful life of
your iron. Nevertheless the “anti-calc” cartridge
cannot remove all of the scale that is produced
naturally over time.
4. Calc’nClean with descaling liquid
For deep descaling, it is recommended to use the
descaling liquid especially developed by Bosch.
This procedure should be carried out every 3
months.
• Fill the water tank with tap water mixed with a
measure (25 ml) of the descaling luid.
• Then follow the procedure described above in
section “Calc’nClean” (steps 2 to 7)