PASCO ME-6960 PASTrack - Manual (Page 2)

®
P A S tr a c k M E- 6 9 6 0
2
2. Slide the other track section onto the connector piece. Push it
until it snaps.
3. Turn the track upside down and tighten the screws on the
connector (part a in figure 1).
Leveling
1. Set the track upright on a level surface.
2. Place a cart on the track to test it for level.
3. Adjust the feet to make the track straight and level.
4. Tighten the locknut of each foot (part e in figure 1).
Rod Mounting
You can use a horizontal rod to elevate one end of the PAStrack
to incline it or two horizontal rods to raise the entire track for dis-
play. The PAStrack accepts rods up to 9.5 mm in diameter (such
as PASCO part SA-9242).
Insert a rod into one of the rod clamp holes (figure 2) and secure
it by tightening the rod clamp screw (part c in figure 1). Clamp
the horizontal rod to a vertical rod.
Figure 2
Disassembly
1. Loosen the connector screws.
2. Press and hold the release tabs on the bottom of the track
(part b in figure 1).
3. Pull the track sections apart.
For Best Results
• Engage and disengage each new connector several times to
break it in and make subsequent assembly easier.
• If one end of the PAStrack is elevated, ensure that the con-
nector screws are tightened to prevent the track from bow-
ing.
• If you are using multiple PAStracks joined together on a
level surface, leave the connector screws loose. This will
make each joint slightly flexible and allow you to use the
feet to level each section separately.
• To protect your PAStrack during storage, disassemble it and
keep it in its original box.
Technical Support
For assistance with any PASCO product, contact PASCO at:
Limited Warranty For a description of the product warranty, see the
PASCO catalog.
Copyright
The PASCO scientific 012-10384A PAStrack Instruction
Sheet is copyrighted with all rights reserved. Permission is granted to
non-profit educational institutions for reproduction of any part of this man-
ual, providing the reproductions are used only in their laboratories and
classrooms, and are not sold for profit. Reproduction under any other cir-
cumstances, without the written consent of PASCO scientific, is prohibited.
Trademarks
PASCO and PASCO scientific are trademarks or registered
trademarks of PASCO scientific, in the United States and/or in other coun-
tries. All other brands, products, or service names are or may be trade-
marks or service marks of, and are used to identify, products or services
of, their respective owners. For more information visit
www.pasco.com/legal.
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Phone: 916-786-3800 (worldwide)
800-772-8700 (U.S.)
Fax: (916) 786-7565
Web: www.pasco.com
Email: [email protected]