PASCO ME-6960 PASTrack - Manual

I n s tr u c t i o n S he e t
0 1 2 - 1 0 3 8 4 A
800-772-8700 www.pasco.com
®
PAStrack
ME-6960
Quick Start
1. Connect the track sections using one of the connector pieces.
2. Tighten the screws on the connector.
Introduction
The PAStrack is designed for use with PASCO carts, dynamics
system accessories, and optics carriages.
The model ME-6960 track consists of two sections that can be
joined together with the included connector and split apart for
storage. Together the two sections form a 1 m track. Each
PAStrack kit includes an extra connector, allowing any number of
tracks to be joined together.
You can use the PAStrack on a level surface or elevate one end to
make an inclined plane.
Parts of the PAStrack
Figure 1
a. Connector screws
b. Release tab
c. Rod clamp screw
d. Rod clamp hole
e. lock nut
f. foot
Assembly
1. Slide a connector piece into the “50 cm” end of one track
section. Push it hard until you hear it snap.
1
2
3
4
Included Equipment
1. 0 cm to 50 cm section
2. 50 cm to 100 cm section
3. Connectors (2 pieces)
4. Leveling Feet with locknuts (6 pieces)
b
c
d
a
e
f