PASCO CI-6685 BNC ADAPTER - Manual

Instruction Sheet
for the PASCO
Model CI-6685
BNC ADAPTER
012-07157A
6/99
$1.00
© 1999 PASCO scientific
Introduction
The PASCO CI-6685 BNC Adapter adapts a BNC
connector to a 5-pin DIN connector. The BNC
Adapter allows sensors with BNC connectors to be
used with a PASCO ScienceWorkshop
®
computer
interface to measure voltages ranging from -10 volts
to +10 volts.
Equipment
I NCLUDED
• BNC adapter (CI-6685)
• 2-meter cable with 5-pin DIN connectors
ADDITIONAL REQUIRED
• Any PASCO Science Workshop computer
interface (300, 500, or 700 series for Macintosh or
Windows) or the 6500 series interface for DOS
Connecting a probe’s ground lead
to any potential other than ground
could cause damage to the circuit
being measured, the BNC Adapter,
or the ScienceWorkshop Interface.
Warning
Application of electrical voltage in excess of the
values listed in the product specification section
may damage this product, create a safety hazard,
and may endanger the oper-ator. This device
does not use or produce voltages that exceed
42.4 VAC peak, 30 VAC RMS, or 60 VDC.
BNC connector
BNC Adapter
extension cable
5-pin DIN connector
5-pin DIN connector