PASCO ME-6977 Fan Cart - Manual (Page 3)

®
Model No.ME-6977 Introduction
3
Operation
The control section of the Fan Cart has eleven light-emitting diodes (LEDs), a
VARIABLE THRUST knob, and three selector switches: THRUST, PULSE TIME,
and FAN ON, STANDBY. The CHARGING LED flashes when the battery needs to
be recharged and stays lit while the Fan Cart is charging.
FAN ON, STANDBY, and OFF
To turn on the Fan Cart, press the FAN ON, STANDBY selector switch. The LEDs
will light momentarily, and then the green LED next to STANDBY will remain lit.
To turn on the fan, press the FAN ON, STANDBY selector switch again. The fan
will turn on and the yellow LED next to FAN ON will remain lit. The default setting
is continuous blowing at LOW THRUST.
To turn off the fan, press the FAN ON, STANDBY selector switch again. The fan
will turn off and the green LED next to STANDBY will remain lit.
To turn off the Fan Cart, press-and-hold the FAN ON, STANDBY selector switch
for one or two seconds. The green LED next to STANDBY will stop shining.
THRUST Settings
To change the THRUST setting from the default value (LOW), press the THRUST
selector switch once to select MEDIUM. Press the selector switch again to select
HIGH, and press the selector switch again to select VARIABLE. Press the selector
switch once again to return the THRUST setting to the default value.
When the THRUST setting is set to VARIABLE, turn the VARIABLE THRUST
knob clockwise to increase the thrust or counterclockwise to decrease the thrust.
You can change the THRUST setting while the fan is in STANDBY, or while the fan
is on.
PULSE TIME Settings
You can change PULSE TIME settings only while the fan is in STANDBY.
Press the PULSE TIME selector switch once to select 1 s (one second). Press the
switch again to select 2 s (two seconds). Press the switch again to select 4 s (four sec-
onds), and press the switch again to select 6 s (six seconds).
THRUST
selector switch
VARIABLE
THRUST
knob
CAUTION!
Keep fingers and other
objects away from the moving
fan blade.
NOTE: The Fan Cart turns
itself off if is not used for ten
minutes.
FAN ON, STANDBY
selector switch
PULSE TIME
selector switch