Appendix – PASCO ME-9430 Dynamics Cart with Mass User Manual

Page 27

012-04840E

Dynamics Cart

Appendix

WARNING!

If the baseplate is removed, the axle assemblies
may fly out, because they are held in place by
compressed springs.

Removal of the plate is a two person operation:
One person needs to push down on the wheels
while the other slides out the base plate.

Replacing the Wheel-Axles Assemblies

1. Detach the end cap at the rear of the cart by remov-

ing the two screws from the rear end cap as shown.

NOTE: The screws that secure the end caps to
either end of the Dynamics Cart are thread
forming screws and may require substantial force
to remove and reinstall. A #1 Phillips point screw
driver is required.

Replacing the Front End-Cap Attachments

• Screw the plunger bar knob finger-tight onto

the plunger bar.

• Peel off Velcro

tab and replace with new tab.

• The plastic cover may get pulled off the plunger

bar catch. Replace with the new cover.

• If the plunger bar becomes defective, please con-

tact PASCO scientific for technical support.

Baseplate

Wheel-axle

assembly

Compression

spring

4. Slide the baseplate back into position.

5. Replace the rear end cap with the two screws.

Velcro tab

Plunger bar knob

Plastic cover

2. Push the wheels into the recessed area and slide the

base plate over the wheels.

3. Replace the wheel-axle assembly and springs in re-

verse order.

Rear Endcap

Thread forming

Screws

Plunger bar

trigger

Plunger bar

catch