PASCO PS-2001 PowerLink - Manual (Page 2)

2
®
The PS-2001 can be used whenever a USB Link (PS-2100) or an Xplorer (PS-2000) is used.
USB Hub
1. Features: self-powered, full speed, 2 ports.
2. Use of the 2 hub ports requires the AC adapter.
3. Each USB hub port has an LED next to the connector that, when lit, indicates active
status. An over-current condition or lack of the AC adapter will turn off the LEDs.
Operation Requirements
DataStudio Software, version 1.8 or higher, and a USB-compatible computer are required to
operate the PowerLink.
Battery Operation
1. Batteries can be used for USB connection to a computer (laptop for example) or an AUX
port connection to a PDA.
2. With battery operation, connecting to the USB or PDA port will turn on the PowerLink.
Disconnecting the USB or PDA connection will turn it off.
3. Battery fuel gauge can be read from the PDA interface.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.