PASCO ME-6955 1.2 m PAScar Dynamics System - Manual (Page 5)

®
M o d e l N o . M E - 6 9 5 5 S p a r e P a r t s
5
Adjustable Feet Attach the feet to the track as illustrated.
Turn the feet screws to level the track then tighten the lock nuts
to secure them.
For maximum stability, position the feet about 1/4 of the track
length from each end
Adjustable End Stops Attach the end stops to the track
as illustrated. The end stops contain magnets to repel the mag-
netic bumper of a cart. A stud is provided as an attachment
point for a spring.
Pivot Clamp Attach the pivot clamp to the T-slot of the track (as illustrated) to ele-
vate one end of the track on a vertical rod.
Spare Parts
You can order any of the major components of the system using the part numbers
listed in the table on page 3. For an assortment of thumbscrews, square nuts, and other
small parts, order the IDS Spares Kit (ME-9823)
For help identifying a part, contact PASCO technical support (see page 27).
2
1
3
4
Adjustable Feet
1: Slide tab into T-slot. 2: Tighten thumbscrew to
secure feet set. 3: Turn feet screws to level track.
4: Tighten lock nuts to secure feet screws.
1/4 1/4
1
2
3
4
Adjustable End Stop
1: Slide tab into T-slot on side of track. 2: Tighten
thumbscrew to secure end stop. 3: Magnets repel
cart’s magnetic bumper 4: Spring attachment stud
Pivot Clamp
T-slot