Pach and Company AeGIS 4000P Manual - Manual (Page 31)

HANG-UP AEGIS CALLS FROM
PREMISE OR REMOTE
LOCATION
CALL AND TALK TO THE AEGIS
FROM PREMISE OR REMOTE
LOCATION
Step 5 Enter another Function Code to program another parameter otherwise press ∗ to
exit and you will hear “Three Short ”.
From Premise Location
Step 1 Pick up your handset and wait for a dial tone.
Step 2 Press # # and you will hear “One Short Beep” then
Step 3 Press 9 to Unlock Cycle Relay 1 (door 1), you will hear “Two Short Beeps” or
Press 8 to Unlock Hold Relay 1 (door 1), you will hear ” Two Short Beeps”. If door
or gate is unlocked, you will hear “No Beep” or
Press 7 to lock Relay 1 (door 1), you will hear “One Short Beep”. Then you are
disconnected.
OR
Press 5 to Unlock Cycle Relay 2 (door 2), you will hear “Two Short Beeps” or
Press 4 to Unlock Hold Relay 2 (door 2), you will hear ” Two Short Beeps”. If door
or gate is unlocked, you will hear “No Beep” or
Press 3 to lock Relay 2 (door 2), you will hear “One Short Beep”. Then you are
disconnected.
From Remote Location
Step 1 Pick up your handset and wait for a dial tone and dial the system phone number.
You will be connected to the system after a certain number of rings preprogrammed
on Function Code 96 and you will hear “One Short Beep” if the gate is locked or
“Two Short Beeps” if the gate is unlocked.
Step 2 Press # then 4-digit Master Code and you will hear “One Short Beep” if the
master code is accepted or the call will be disconnected if the master code is
invalid.
Step 3 Press 9 to Unlock Cycle Relay 1 (door 1), you will hear “Two Short Beeps” or
Press 8 to Unlock Hold Relay 1 (door 1), you will hear ” Two Short Beeps”. If door
or gate is unlocked, you will hear “No Beep” or
Press 7 to lock Relay 1 (door 1), you will hear “One Short Beep”. Then you are
disconnected.
OR
Press 5 to Unlock Cycle Relay 2 (door 2), you will hear “Two Short Beeps” or
Press 4 to Unlock Hold Relay 2 (door 2), you will hear ” Two Short Beeps”. If door
or gate is unlocked, you will hear “No Beep” or
Press 3 to lock Relay 2 (door 2), you will hear “One Short Beep”. Then you are
disconnected.
Hanging-up the AeGIS calls from a premise or remote location:
• Wait until the talk time expires or
• Hang-up the handset or
• Press
∗ ∗
From Premise Location
Step 1 Pick-up the handset.
Step 2 Press # # and you will hear “One Short Beep”.
Step 3 Press ∗ and now you are ready to talk to the AeGIS system. You may press 9 to
open door or gate.
From Remote Location
Step 1 Pick-up the handset and wait for dial tone.
DESCRIPTION ACTION
Pach and Company Page 23
AeGIS 4000P Chapter 4. Operations