Pach and Company AeGIS 4000P Manual - Manual (Page 16)

CHAPTER 3. PROGRAMMING CHAPTER 3. PROGRAMMING
The AeGIS 4000P can be programmed Local (using built-in keypad), Premise Phone or Remote Phone. Premise phone
programming can only be used if the existing Central Office Line is connected to the system as shown in figure 2.1.
Pach and Company Page 8
AeGIS 4000P Chapter 3. Programming
Local Programming Premise Phone Remote Phone Keys
Press this key once to exit from the
programming mode, you may need to
press the key twice to exit if you
already in the select function mode
Press this key
• once to accept program.
Press the black round button, see
diagram, to log in to programming
without the master code
Press this key
• Twice to initiate the call to the
AeGIS 4000P, see function code
98 (must be selected to use * ).
• Twice to disconnect the call with
the AeGIS 4000P.
Press this key
• Twice to initiate the call to the
AeGIS 4000P, see function code
98 (must be selected to use #).
• Once to Extend the talk time for
another cycle.
• Once to accept program.
Press this key twice to disconnect the
call with the AeGIS 4000P.
Press this key once to accept
program.
*
#
O
MASTER CODE
RETRIEVAL
BUTTON
Master Code cannot be replaced using
the premise phone. Master Code cannot be replaced using
the remote phone.
00
CHANGE UNIT
MASTER CODE
The default system Master Code
(0000) must be changed for security
purposes. The Master Code is always
4-digit long.
Step 1 Entering The Programming
Mode: Press 0 and # simultaneously
then release. If you are in the
programming mode, proceed to step 2.
Step 2 Enter the 4-digit Master
Code (factory default is 0000) and you
will hear “One Short Beep”. If you
entered an invalid master code you will
hear “One
Long Beep”, repeat
step 1. Should your master code
become lost or forgotten see Reset
Master Code.
Function Local Programming Premise Phone Remote Phone