Nova-Tech pH 110 - Manual (Page 27)

Instruction Manual CyberScan pH 11 / 110
23
8 PRINT FUNCTION (Only for pH 110)
The pH 110 meter is equipped with an RS232 communication port and a PRINT ( )
key that facilitate the printing of data from the meter to a printer or computer.
8.1 Using pH 110 Meter With Printer or Computer
1. To use the pH 110 directly with a printer, the printer should have either a 9
pin or a 25 pin RS 232C serial port.
2. Communication settings of the printer or computer’s data acquisition software
(CyberComm Portable DAS) MUST match the following parameters:
a. Baud Rate: 9600
b. Parity Bit: None
c. Stop Bit: One
d. Data Bit: 8
e. Flow Control: None
3. Please refer to your printer’s or computer’s instruction manual for more
information on its communication setup protocol.
4. Use 9-pin cable (Refer to section 15 - LIST OF ACCESSORIES on page 65)
to connect the meter to the printer. If the printer has a 25 pin connector, use
the 9 to 25 pin cable or make your own cable taking note of the connection
parameters as described in section 3.4 - Connecting the RS232C Cable
(Only for pH 110) on page 9.
5. Turn on pH 110 meter and note the following:
f. For printer, ensure it is powered on and paper is loaded.
g. For computer, ensure that Eutech Instruments’ CyberComm Portable
Data Acquisition Software is installed and activated. See section 10.3 -
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682