Nova-Tech pH-Dissolved Oxygen Meter - Manual (Page 27)

53 52
From measurement mode:
1. Press the MODE key to select mg/l
(ppm) mode.
2. Press SETUP key to enter SETUP mode.
3. Press the ▲ and ▼ keys to scroll through
subgroups until you view parameter P4.0
in the lower display.
See figure
4. Press the ENTER key until “dO”
appears in the upper display, P4.2 in the
lower display.
See figure
5. Press the ▲ and ▼ keys to toggle
between mg/l or ppm units.
6. Press the ENTER key to confirm
selection and move to P4.3 on page
53. Press the CAL/MEAS key twice to
return to measurement mode.
P4.2: Selecting mg/l or ppm units
This mode lets you select between mg/l or ppm dissolved oxygen units.
SETUP
SETUP
mg/l
SETUP
ppm
C
D
P4.3: Selecting °C or °F temperature readout
This meter lets you select between °C and °F units for temperature readings.
From measurement mode:
1. Press the MODE key to select mg/l
(ppm) mode.
2. Press SETUP key to enter SETUP mode.
3. Press the ▲ and ▼ keys to scroll through
subgroups until you view parameter P4.0
in the lower display.
See figure
4. Press the ENTER key until “C” or “F’
appears in the upper display.
See figure
5. Press the ▲ and ▼ keys to toggle
between °C and °F.
6. Press the ENTER key to confirm
selection and to return to the subgroup
menu. Press the CAL/MEAS key to
return to measurement mode.
SETUP
SETUP
C
F
SETUP
E
E
F
F
C
D
NOTES:
You can also switch between °C and °F in SETUP Program P3.3 on page 37 in pH
mode or Program P5.2 on page 44 in mg/l (ppm) mode. If you switch between °C and
°F in mg/l (ppm) mode, the meter will also switch in pH and % saturation modes.
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682