Nova-Tech pH-Dissolved Oxygen Meter - Manual (Page 16)

From the % saturation measurement mode
dPr: Dissolved oxygen parameters
• Select Hg or Pa barometric pressure units
• Select barometric pressure
CAL: Viewing previous calibration data
• View previous calibration data
OFS: % saturation offset adjustment
• Set % saturation offset adjustment
ELE: Viewing probe data
• View probe slope
• View % saturation offset
• View mV value equivalent to 100% saturation
• View mV value equivalent to 0% saturation
COF: Unit configuration
• Ready indicator on or off / auto endpoint on or off
• Select °F or °C
LCd: Backlit display
• Adjust brightness of backlit LCD
Instructions on page 39
SETUP
Instructions on page 40
SETUP
Instructions on page 41
SETUP
Instructions on page 42
SETUP
Instructions on page 43-44
SETUP
Instructions on page 45
SETUP
rSt: Reset to factory default
• Reset to factory default settings
Instructions on page 46
SETUP
From the mg/l (ppm) measurement mode
dPr: Dissolved oxygen parameters
• Select Hg or Pa barometric pressure units
• Select barometric pressure
• Select salinity adjustment factor
CAL: Viewing previous calibration data
• View previous calibration data, including date/time
ELE: Viewing probe data
• View probe slope
• View mV value equivalent to 100% saturation
• View mV value equivalent to 0% saturation
COF: Unit configuration
• Ready indicator on or off / auto endpoint on or off
• Select mg/l or ppm units
• Select °F or °C
rSt: Reset to factory default
• Reset to factory default settings
Instructions on page 47-48
SETUP
Instructions on page 49
SETUP
Instructions on page 50
SETUP
Instructions on page 51-53
SETUP
Instructions on page 55
SETUP
LCd: Backlit display
• Adjust brightness of backlit LCD
Instructions on page 54
SETUP
31 30
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682