Nova-Tech pH-Dissolved Oxygen Meter - Manual (Page 23)

45 44
P5.2: Selecting °C or °F temperature readout
This meter lets you select between °C and °F units for temperature readings.
From measurement mode:
1. Press the MODE key to select the
% saturation measurement mode.
2. Press SETUP key to enter SETUP mode.
3. Press the ▲ and ▼ keys to scroll through
subgroups until you view parameter P5.0
in the lower display.
See figure
4. Press the ENTER key until “C” or “F’
appears in the upper display.
See figure
5. Press the ▲ and ▼ keys to toggle
between °C and °F.
6. Press the ENTER key to confirm
selection and to return to the subgroup
menu. Press the CAL/MEAS key to
return to measurement mode.
SETUP
SETUP
C
F
SETUP
E
E
F
F
% saturation mode—P6.0: Adjusting LCD brightness
This mode lets you adjust the brightness of the backlit LCD. Selecting a dimmer
backlighting level helps conserve batteries.
8.11
From measurement mode:
1. Press the MODE key to select the
% saturation measurement mode.
2. Press SETUP key to enter SETUP mode.
3. Press the ▲ and ▼ keys to scroll through
subgroups until you view parameter P6.0
in the lower display.
See figure
4. Press the ENTER key. A number (0-8)
appears in the upper display and “LCd”
appears in the lower display.
See figure
5. Press the ▲ and ▼ keys to select
from level 0 (dimmest light) to level 8
(brightest light).
6. Press the ENTER key to confirm selec-
tion and to return to the subgroup menu.
Press the CAL/MEAS key to return to
measurement mode.
SETUP
SETUP
A
A
B
B
NOTES:
You can also switch between °C and °F in SETUP Program P3.3 on page 37 in pH
mode or Program P4.3 on page 53 in mg/l (ppm) mode. If you switch between °C and
°F in % saturation mode, the meter will also switch in pH and mg/l (ppm) modes.
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(866) 433-6682