Nova-Tech PGL Series - Manual (Page 16)

8) During parts counting checks will be made to determine that the weight of the
reference parts is large enough for reasonably accurate counting (weight of
each piece should be > 1d)
7.2 PERCENT WEIGHING
Percent weighing will be done by defining a certain weight to be 100%. The
weight to be used can either be entered by the user or taken from a sample.
Steps:
1) Press [Mode] and then the [Up] or [Down] key to select Percent weighing,
“PERCENT” will be displayed
2) Press [Enter] to enter the function
3) Display will show, “PERCENT SAMPLE”
4) Press [Enter] to select the sample method (see step 5) or press the [Up] or
[Down] key to select the manual entry of weight method (see step 9).
5) When “LOAD 100 %” is shown, add the sample
6) Press [Enter] to set this weight to be 100%, the busy symbol will turn on.
When ready the display will show “100%”
7) Remove the sample and place an unknown sample to display the percentage
weight
8) To set another weight as 100%, press [Mode] and continue from step 2 above.
9) To manually enter a value to be set as 100%, press [Up] or [Down] key when
“PERCENT SAMPLE” is shown to select “PERCENT Ent Wt”
10) Press [Enter] to select the manually entered weight method
11) Enter the weight using the numeric entry method (see section 5.1)
16 | P a g e © Adam Equipment Company 2008