Nova-Tech IHS 2a - Manual (Page 17)

whenever a stable reading is present.
The balance has to return to zero
before another reading is sent via the
interface.
Press the [Mode] key to change the setting. Press [Tare] to confirm and move
to the next parameter.
7) Setting the baud rate. This is the transmission speed for communication with
printers and computers. The selected rate must match that of the other
device for communications to work.
The following settings are available:
b 600
b 1200
b 2400
b 4800
b 9600
Press the [Mode] key to change the setting. Press [Tare] to confirm and move
to the next parameter.
8) Parity settings. Parity is a communications check. There are 3 settings that the
Highland can work with as follows:
8 n 1
8 data bits, no parity
7 E 1
7 data bits, even parity
7 0 1
7 data bits, odd parity
Press the [Mode] key to change the setting. Press [Tare] to confirm and move
to the next parameter.
9) The display will go back showing F3 SEr. Press the [Print] key to return to
weighing or press [Mode] to go to the next function.
17 | P a g e © Adam Equipment Company 2008