Nova-Tech CBK Series User Manual

Page 19

© Adam Equipment Company 2007

if 3500g is placed on the scale and percent weighing is selected,

the

display will show 100.00%. Remove the 3500g weight and place a
3000g weight. The display will show 85.7% as 3000g is 85.7% of
3500g.

• The number of decimal points will depend on the weight used. A

smaller weight will show only “100%” while a larger weight might show
“100.00%”.

• If the scale was showing zero weight when entering this function, then

the user must manually enter the weight to be set as 100%. Press
[Tare] to accept the reference weight. The display will show “0.00 %”.

• If the scale shows “x x . x x %”, which is the last weight used as a

reference, press

[CE] to clear and use the numeric keypad to enter a

new value. Press

[Tare] to accept the new reference weight.

• The weight entered must be greater than 50 scale divisions.

• Press [Unit] to return to weighing.

NOTE:

The display may jump by large numbers unexpectedly if small weights are
used to set as 100% reference. For example, if only 23.5g is placed on a
scale with 0.5g increments and is set to 100%, the display will show
100.00%. However a small change of weight will cause the display to jump to
102.13% as an increase of one scale division (0.5g) to 24.0g will be
equivalent to an increase of 2.13%.

10.8 ACCUMULATED TOTAL

The scale can be set to accumulate when a weight is added to the scale
automatically or manually by pressing

[Print]. See Section 13.2.