Nova-Tech CBK Series - Manual (Page 13)

© Adam Equipment Company 2007
11
NOTE:
When the container is removed a negative value will be shown. If the scale
was tared just before removing the container, this value is the gross weight of
the container plus all products which were removed. The zero indicator will
also be on as the platform is back to the same condition it was when
[Zero]
was pressed last.
Press
[Tare] or [Zero] to remove the tare value and display zero. The Net
indicator will disappear.
10.2.2 Preset Tare
When the scale is at zero with no weight on the platform it is possible to enter
a preset tare.
• Zero the scale by pressing [Zero]. The zero indicator will be on.
• Enter a value using the numeric keys.
• Press [Tare] to tare the scale. The value that was entered is
stored as the tare value and it is subtracted from the display,
leaving a negative number on the display.
10.3 WEIGHING
To determine the weight of a sample, first tare an empty container if
used, then place the sample in the container. The display will show the
weight and the unit of weight currently in use.
To change the weighing unit press the [Unit] key. Weighing units
displayed are the ones that are enabled by the user in the parameters
section. See section 13.3.
10.4 PARTS COUNTING
The scale can be used to count parts based on the average weight of a
sample weighed on the scale. When more parts are added the total
number of parts is displayed.