Vap/vlan settings / 802.1q vlan setup in ap mode – Nitek MNG6448 User Manual
Page 17
17
VAP/VLAN Settings / 802.1Q VLAN Setup in AP Mode
In Access Point mode, you could enable 802.1Q VLAN to manage users, You could select one profile to edit as
follows:
Figure 13 802.1Q VLAN
One device could be used to eight devices. So you could easy setup your network and manage different users.
And the eight VAP could set different security to protect your network.
Management VLAN ID: Management VLAN ID is used to manage device and monitor the network.
Security Profile VLAN ID: Security Profile VLAN ID is used to manage VLAN. You could set ID 1~4049.
Security Profile Settings following steps below:
See also other documents in the category Nitek Hardware:
- UTPSYS16 (6 pages)
- VB43ATF (2 pages)
- VB31AT (7 pages)
- PVX44 (1 page)
- PVX164 (1 page)
- PVR164 (2 pages)
- PV824 (2 pages)
- PV424 (2 pages)
- PS115 (4 pages)
- POE48 (1 page)
- FAN64 (1 page)
- CHM22 (1 page)
- CHM22 (1 page)
- CX452 (8 pages)
- DA422 (1 page)
- TR560x4 (2 pages)
- TR515x4 (2 pages)
- VB41x4 (2 pages)
- RK400 (1 page)
- TR515x8 (2 pages)
- VB41x8 (1 page)
- VH3200 (2 pages)
- VH3256 (4 pages)
- VH3251 (4 pages)
- VH3239 (4 pages)
- VH1656M (4 pages)
- VH1651M (4 pages)
- VH1639M (2 pages)
- VH456 (2 pages)
- VH451 (2 pages)
- VH439 (2 pages)
- EX1120 (12 pages)
- EX560 (4 pages)
- TS560 (8 pages)
- TS515 (8 pages)
- TS510M (3 pages)
- CAMTRV24 (2 pages)
- VB39M (7 pages)
- VB39F (7 pages)
- VB37M (7 pages)
- VB31M (7 pages)
- VB31PT (7 pages)
- FTS58111xR00 (5 pages)
- FTS541000S00 (4 pages)
- FTS54110xS00 (5 pages)