Multichannel Systems USB-MEA256-System Manual - Manual (Page 21)

USB-MEA256-System
15
The following screen shot shows a recording from a USB-MEA256-System with a test model
probe and a sampling rate of 40 kHz.
Setting up an Experiment
Open the lid of the amplifier. Place the 256MEA chip inside the USB-MEA256 amplifier.
The pin layout is described in chapter “Pin Layout” in the Appendix. The MEA256 is rotationally
symmetrical, so in principle the orientation in the amplifier doesn’t matter. If the orientation
is important for your experiments, you can use the engraved serial number as marker.