Mallory Ignition ACCEL 3 stage rev_limiter 49345 - Manual (Page 8)

T HE SQUARE , 4- PIN , FEMALE CONNECTOR
outputs directly to your ignition system.
When correctly installed, this connector
is a simple plug-in.
C ONNECTING THE W IRING H ARNESS
HE FLAT , 4- PIN CONNECTOR ’s RED wire is attached, through the ignition switch, to the
attery’s positive pole (+12 VDC ).
he battery’s negative pole is grounded,
nd this connector’s B LACK wire must also
e attached to a good negative ground,
referably the Ground Strap.
he D ARK GREEN & W HITE wire connects to
he Burn Out switch. When the Burn Out
witch is set ( ON ) the 3-Stage Rev-limiter
ev-limits the engine at the value stored
or B
URN RPM .
he D ARK B LUE & W HITE wire is spliced to the wire connecting the Staging switch to
he Trans Brake, or the Line Lock solenoid. When this switch is released your engine is
ree to rev up to the value set for P EAK RPM .
T HE S HIFT L IGHT C ONNECTOR is one of the
two 2-pin connectors. Its R ED & W HITE wire
provides +12
VDC
. Its B LACK & P INK wire is
switched to ground when the engine reaches
the speed programmed in S
HIFT L IGHT .
T HE N 2 O S OLENOID C ONNECTOR is the other
2-pin connector. Its P INK wire also provides
+12 VDC . Its B ROWN wire is also switched, to
ground when the engine reaches the speed
programmed in by the N
2 O S WITCH .