Magnum Venus Plastech CB-8000-xxx Resin Monitor - Manual (Page 11)

INSTALLATION AND OPERATIONS MANUAL CB-8000-XXX
MAGNUM VENUS PLASTECH REV 1.05
APRIL 2013 PAGE 11
CHAPTER 3-Installation
The CB-8000-XXX comes with hardware to mount unit to a 2” column which is standard on most MVP systems, and
will mount to any flat surface that is suitable to hold the weight of the unit.
Please refer to the reference label on the panel for proper electrical supply connections.
Note:
*Because of the variety of electrical codes in various parts of the world, MVP does not supply main power
connections to any of the material monitors mentioned in this manual. The electrical connection should be made by
a qualified electrician per codes of local jurisdiction.
**Due to the sensitivity of the sensor cables used on the CB-8000-XXX, proper installation of the cables is very
important. Cables must be kept as far away from electrical sources (ungrounded conduit, PWM drives, tach
generators etc.) as to not create interference with the input signals. In some extreme instances, EMI filters may
need to be installed to make the unit work properly.
***The end user is responsible for ensuring that the end product or system complies with all the relevant laws in
the country where it is to be used and that all documentation and general electrical practices are adhered to.
Please contact your local MVP representative for further information.