Magnum Venus Plastech TESTING & ADJUSTING YOUR MVP PUMPING SYSTEM User Manual
Page 44

Testing & Adjusting Manual
Rev. 01/2013
Page | 44
TEST NOTES
Name of material being used:
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
Catalyst Percentage: __________%
Catalyst type: _________________________________________________________
Material is being: Sprayed Poured
Other:_____________________________
This material was successfully applied under the following conditions:
Winter
Spring
Summer Fall
Air temperature of the factory ________ degrees
Relative humidity of the factory _______ %
Other conditions:
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
Power head pressure ________________psi
Catalyst Accumulator charge _____________psi
Resin Accumulator charge _______________psi
In-line Heater setting __________________
Nozzle size _________________
Nozzle Fan Angle _______________degrees