Magnum Venus Plastech TESTING & ADJUSTING YOUR MVP PUMPING SYSTEM - Manual (Page 10)

Testing & Adjusting Manual
Rev. 01/2013 Page | 10
D. Never add MEKP to anything that is hot, since explosive decomposition may result.
E. Avoid contact with skin, eyes and clothing. Protective equipment should be worn at all times.
During clean-up of spilled MEKP, personal safety equipment, gloves and eye protection must be
worn. Firefighting equipment should be at hand and ready.
F. Avoid spillage, which can heat up to the point of self-ignition.
G. Repair any leaks discovered in the catalyst system immediately, and clean up the leaked
catalyst at once in accordance with the catalyst manufacturer’s instructions.
H. Use only original equipment or equivalent parts from Magnum Venus Plastech in the catalyst
system (i.e.: hoses, fitting, etc.) because a dangerous chemical reaction may result between
substituted parts and MEKP.
I. Catalyst accumulated from the purging of hoses or the measurement of fluid output deliveries
should never be returned to the supply tank, such catalyst should be diluted with copious
quantities of clean water and disposed of in accordance with the catalyst manufacturer’s
instructions.
The extent to which the user is successful in accomplishing these ends and any additional
recommendations by the catalyst manufacturer determines largely the safety that will be present
in his operation.
2.3 Clean-Up Solvents and Resin Diluents
WARNING
A hazardous situation may be present in your pressurized fluid system! Hydrocarbon
Solvents can cause an explosion when used with aluminum or galvanized components in
a closed (pressurized) fluid system (pump, heaters, filters, valves, spray guns, tanks,
etc.). The explosion could cause serious injury, death and/or substantial property
damage. Cleaning agents, coatings, paints, etc. may contain Halogenated Hydrocarbon
Solvents. Some Magnum Venus Plastech spray equipment includes aluminum or
galvanized components and will be affected by Halogenated Hydrocarbon Solvents.
A. There are three key elements to the Halogenated Hydrocarbon (HHC) solvent hazard.
a. The presence of HHC solvents. 1,1,1 – Trichloroethane and Methylene Chloride are
the most common of these solvents. However, other HHC solvents are suspect if
used; either as part of paint or adhesives formulation, or for clean-up flushing. b.
Aluminum or Galvanized Parts. Most handling equipment contains these elements. In
contact with these metals, HHC solvents could generate a corrosive reaction of a
catalytic nature.
b. Equipment capable of withstanding pressure. When HHC solvent contact aluminum or
galvanized parts inside a closed container such as a pump, spray gun, or fluid
handling system, the chemical reaction can, over time, result in a build-up of heat and
pressure, which can reach explosive proportions.
When all three elements are present, the result can be an extremely violent explosion. The
reaction can be sustained with very little aluminum or galvanized metal; any amount of
aluminum is too much.