Magnum Venus Plastech CHOP CHECK FLUID CCPLS-1000 - Manual (Page 22)

CCPLS-1000 Fluid Section Manual
Rev. 08/2012 Page | 22
17. Remove the Spring Support Ring (CCPLS-1005) and Wave Springs (CCPLS-
1029) from inside of the Outlet Body.
18. Remove the Female Compression Ring, Male Compression Ring and V Packing
(CCPLS-1002) from inside of the Outlet Body.
Note: If the parts are hard to remove from the top of the Outlet Body use a
wood or plastic dowel to push the parts out from the bottom. Cleaning with a
solvent will help loosen stuck parts.
Displacement Rod Disassembly
–
Note: Clean and inspect all parts for wear and damage. Replace damaged
parts and all parts provided in the repair and seal kits.
1. Unscrew the Lower Piston Body from the Upper Piston Body. Use caution, the
piston ball may fall out and become damaged. If the ball falls onto a hard surface
it may become scratched or get a flat spot on it.
2. Remove the Piston Ball and Ball Check Spring (3102-16-1) from the Upper
Piston Body.
3. Remove the Piston Cups (CCPLS-1009), Piston Cup Spacer and Piston Cup
Backup Ring from the Lower Piston Body.