Magnum Venus Plastech CHOP CHECK FLUID CCPLS-1000 - Manual (Page 17)

CCPLS-1000 Fluid Section Manual
Rev. 08/2012 Page | 17
Requirements:
Air Requirements:
Clean, dry compressed air must be available at up to 90 psi (6.3 kg/cm
2
) and a minimum volume
of 10 CFM (0.3 m 3 ). Air must be provided through an air hose with a diameter of 0.5 inch (1.3
cm) or greater.
Tool and Supplies Requirements:
When performing service and repair on the Fluid Section, you should have the following tools,
spare parts and supplies available before beginning.
NOTE: Items followed by a * may be purchased from Magnum Venus Plastech.
 One table vise
 Loctite™ 243 (removable) or equivalent thread lock compound
 One small hammer
 Needle-nose pliers
 Solvent or emulsifier for cleaning
 One clean work table
 Anti-seize thread sealant
 Set of hex wrenches * (08469)
 One 5/8-inch wrench * (08474)
 One 9/16-inch wrench * (08476)
 One 5/16-inch wrench * (08477)
 Empty buckets for cleaning
 Clean ¼-inch plastic dowel or rod
 One 8-inch adjustable wrench * (08467)
 One 12-inch adjustable wrench * (08468)
 One 7/16-inch open-end wrench
 One ½-inch socket wrench
 One 7/16-inch socket wrench * (08472)
 Wooden sticks or tongue depressors (for testing)
 Labels and pens (for marking pneumatic lines)
 Clean rags and paint brushes for cleaning equipment
 One tube of medium-weight lithium grease (such as Lubriplate ® lubricant * (08465))
 Large (approximately 3 feet by 10 feet or 1 meter by 3 meters) strips of paper for
performing spray tests.
 One pin wrench * (45031-1) (comes with catalyst jug)
 One scribe * (08126)
 Red Grease * (6706-2-1 1oz can) (6706-2-16 16oz can) (6706-2-32 32oz can)
 Seal Kits *
- CCPLS-1000-RK Repair Kit – Chop Check Fluid Sections
- CCPLS-1000-SS-RK Repair Kit
– SS Chop Check Fluid Section