Magnum Venus Plastech CHOP CHECK FLUID CCPLS-1000 - Manual (Page 21)

CCPLS-1000 Fluid Section Manual
Rev. 08/2012 Page | 21
Fluid Section Disassembly:
NOTE: The procedures for disassembly of the Stainless Steel version and
standard steel version will be the same except for Seals in the Intake Valve. For
part numbers see the correct drawing in the Parts Drawing section of this manual.
1. If not already done, move the pump to the bottom of the down stroke.
2.
Remove Hex Cap Screw (F-HB-06F-12) from the bottom of the Priming Rod. If
the Priming Rod spins put a wrench on the wrench flats of the Priming Rod just
above the Priming Piston.
3. Remove the Backup Washers (CCPLS-1028), Relief Washer (CCPLS-1025) and
the Priming Piston from the Priming Rod.
4. Unscrew the four Hex Nuts (7201-12-8) from the end of the Tie Rods (CCPLS-
1020).
5. Pull the Priming Valve Housing off the Tie Rods (CCPLS-1020) and out of the
Foot Valve Housing.
6. Remove Lower Valve Seat from out of the end of the Foot Valve Housing.
7. Slide the Foot Valve Housing off the Cylinder.
8. Unscrew the Tie Rods out of the Outlet Body.
9. Pull the Intake Valve assembly off the Priming Rod.
10. Unscrew the Intake Valve Packing Nut from the Intake Valve.
11. Remove both of the Intake Valve Seal(s) and the Bushing (if applicable) from
inside the Intake Valve.
12. Slide the Valve Stop off the Priming Rod.
13. Pull the Cylinder out of the Outlet Body and off the Piston Cups (CCPLS-1009).
14. Remove the Packing Nut (CCPLS-1006) from the top of the Outlet Body.
15. Pull the Displacement Rod from the V Packing (CCPLS-1002) and Outlet Body,
and set aside for now.
16. Remove the Rod Bushing (CCPLS-1001) from the top of the Outlet Body.