Magnum Venus Plastech CHOP CHECK FLUID CCPLS-1000 - Manual (Page 15)

CCPLS-1000 Fluid Section Manual
Rev. 08/2012 Page | 15
Introduction:
This manual, the CCPLS-1000 FLUID SECTION MANUAL, provides information you need to
perform simple maintenance and repair on your equipment.
 Step-by-step assembly and disassembly procedures are included for each component.
Please read the manual carefully. Follow the steps in the order given, otherwise you may
damage the equipment or injure yourself.
DANGER: Always wear proper safety equipment, including eye protection and gloves
when performing service and repair on this equipment.
This manual covers the following pump assemblies:
CCPLS-1000
Chop Check Fluid Section Assembly
CCPLS-1000-SS Stainless Steel Chop Check Fluid Section Assembly
During Disassembly:
As you disassemble the equipment, lay out the components in the correct order and direction.
This will help you to reassemble them.
Note: the order of the piston cup, piston cup spacer ring, piston cup backup ring and
compression ring and the directions they face. These directions are critical to proper
functioning of this equipment.
Lubrication:
Throughout this manual, directions are given for lubricating various parts of the Fluid Section.
These are typical lubricants used:
 If the part contacts resin, use MVP Red Grease (6706-2-1).
 If the part is located where it will contact air, use Lubriplate ® (08465).
 Throat Seal Oil (TSL-3200) used in the oil reservoir of the pump.
 Throat Seal Oil for use with ISO (TSL-ISO-800) 8 oz.
 Grease for use with ISO (GR-ISO-100) 1 oz.
DANGER: FIRE AND EXPLOSION HAZARD. Never use any lubrication on the
components of the catalyst system. Contact your catalyst manufacturer for additional
material handing information.