Magnum Venus Plastech System One FRP 1100-1-1 User Manual

Page 10

FRP SystemOne

b. Attach the Filter/Surge Chamber Assembly to the swivel fitting

located at the outlet of the resin pump.

c. With the Filter/Surge Chamber Assembly vertical. Tighten the

fitting with a wrench until it is tight enough to prevent fluid leaks and
to support the assembly in an up right position.

6. Mount Catalyst Jug Bracket.

a. Attach the Catalyst Jug Bracket to the base of the catalyst pump

slide drive support.

b. Mount the bracket so it extends to the left side of the slide drive

support as you stand facing the end of the slide drive.

7. Mount Solvent Tank Retainer Bracket.

a. Attach the Tank Bracket to the column approximately 5 inches from

the top of the cart.

b. The bracket arm should be on the backside of the column as you

face the pump, extending to the left side of the cart.

c. Tighten the bolts holding the yoke clamp to the bracket until the

bracket is firmly clamped to the column.

d. Remove the Solvent Tank from the carton and place into bracket.

8. Attach Catalyst Pump.

a. Mount the Catalyst Pump to the slide drive bracket using the clevis

pins and keepers provided.

b. The bottom of the catalyst pump is pinned to the lower leg of the

slide drive bracket.

c. The upper clevis, (piston rod), is pinned to the slide drive using the

hole forward of the long slot in the slide drive.

d. Hold the clevis pins in place with the wire keepers by placing them

in the holes in the clevis pins.

9. Mount Air Supply Manifold.

a. Clamp Manifold Assembly to the pump column above the power

cylinder of the resin pump.

b. Regulators and gauges should face to the pump side of the col-

umn.

c. Clamp yoke tight enough so the assembly does not move around

the column.