Magnum Venus Plastech System One FRP 4102-00-01 - Manual (Page 9)

FRP SystemOne 6
5. Thread the 4101-1-1 (Lock Nut) onto the 4102-6-1 (Cylinder) until it
bottoms on the Cylinder shoulder.
6. Install a 7301-9-014 (O-Ring) onto the long threaded end of the
4102-6-1 (Cylinder).
7. Install the 4102-3-1 (Packing Nut), 4102-4-1 (Upper Guide) and
4102-5-1 (Packing Set) onto the 4102-2-1 (Piston Rod).
8. Carefully insert the 4102-2-1 (Piston Rod) through the 4101-14-1
(Outlet body).
9. Carefully press the 4102-5-1 (Piston Rod Packings), and 4102-4-1
(Upper Guide) into 4101-14-1 (Outlet Body).
10. Screw the 4102-3-1 (Packing Nut) into the 4102-14-1 (Outlet Body).
Screw the Packing Nut until the Packings bottom in the Outlet Body
cavity. Lightly snug the Packing Nut with a wrench.
11. Insert the 4101-3-1 (Piston Rod Spring) into the end of the
4102-2-1 (Piston Rod).
12. Insert the 9201-1-5 (5/32” SS Ball) into the 4102-7-1 (Piston Body).
13. Screw the 4102-7-1 (Piston Body) onto the 4102-2-1 (Piston Rod),
compressing the 4101-3-1 (Piston Rod Spring) onto the 9201-1-5
(5/32” SS Ball).
NOTE
See drawing for proper orientation. See drawing for proper orientation. See drawing for proper orientation. See drawing for proper orientation. See drawing for proper orientation.
NOTE
Care must be taken to not scratch the Piston Rod. Care must be taken to not scratch the Piston Rod. Care must be taken to not scratch the Piston Rod. Care must be taken to not scratch the Piston Rod. Care must be taken to not scratch the Piston Rod.
NOTE
Care must be taken to not damage the Piston Rod Packings. Care must be taken to not damage the Piston Rod Packings. Care must be taken to not damage the Piston Rod Packings. Care must be taken to not damage the Piston Rod Packings. Care must be taken to not damage the Piston Rod Packings.