Lectrosonics Venue (Narrowband) - Manual (Page 14)

Venue Narrowband Receiver
Depending on how microphones are wired and
other vagaries, either position of the INVT toggle
switch might achieve the null. Keep toggling the
switch until the null is found, adjust the level for the
deepest null, then press INVT one more time to put
the transmitter audio back in phase.
3. Repeat Steps 1 and 2 for each receiver module pair
set to Frequency Diversity Mode.
Finding Clear Channels with SmartTune
SmartTune simplifies setup by scanning the tuning
range of the receiver and automatically setting a re­
ceiver module to a clear frequency. A receiver module
is selected, a scan is completed and the frequency is
set for that module. A prompt appears, reminding you to
turn on a transmitter on the newly selected frequency,
and the procedure continues until all modules have
been tuned to clear frequencies.
NOTE: SmartTune is only available using the LCD
and front panel controls. It is not implemented in
the VRpanel software.
1. Navigate to the SmrtTun setup screen.
2. Press the Receiver Select Button for the module
you wish to tune and scanning will begin.
When the full spectrum has been scanned, the cur­
sor will stop moving and blink briefly on the newly
selected frequency.
3. The display will then switch back to the receiver se­
lection screen and ask if you want to tune another
module.
When the transmitter is turned on and detected, the
display will return to receiver selection (Step 2) and
prompt you to select the next receiver.
5. Repeat steps 2 through 4 for all receiver modules
that will be used.
6. Press the Back button several times to return to the
overview screen.
7. Conduct a system checkout with the procedure
explained in the section entitled Diagnostics.
4. If you select Yes the display will remind you to turn
on the transmitter for the receiver you just tuned.
LECTROSONICS, INC. 14