Laurel Electronics LAUREATE SERIES SCALE-WEIGHT METER - Manual (Page 22)

22
Press Menu
Select Key Press Digit
Select Key Press Value Select
Key
_SPI_d
Alarm 1 dribble
value
0.0000 0.0000 0.0000
0.0000 0.0000
Select digit to flash.
_SP2_d
Alarm 2 dribble
value
0.0000 0.0000 0.0000
0.0000 0.0000
Select digit to flash.
Select -9 thru 9 for flashing first digit, 0 thru 9
for other flashing digits. Active high alarms
will activate above the setpoint (positive
dribble value) or below the setpoint (negative
dribble value).
KEYSTROKES FOR VIEWING & CHANGING SETPOINTS
The (Alarms) key can be used to step through and view setpoints while the meter conti-
nues to make conversions and performs setpoint control. If the (Peak) key is pressed while
a setpoint is displayed, conversion stops and the setpoint can be changed. After pressing
,
you have 30 seconds, or the meter will revert to the normal display. To view setpoints, menu
item Loc3, digit 3, must have been set to 0. To change setpoints, menu item Loc4, digit 3, must
have been set to 0.
Press Alarms
Key Press Digit
Select Key Press Value Select
Key
300.24
Press (Alarms)
to display Alarm 1
setpoint.
_ 200.00
Current setpoint 1 digit blinks, and
Alarm 1 LED indicator lights. Press
to select another digit, which will blink.
_ 295.00
To change setpoint 1 value,
press to change the
selected blinking digit value.
395.00
Press (Alarms)
to display Alarm 2
setpoint.
_ 395.00
Current setpoint 2 digit blinks, and
Alarm 2 LED indicator lights. Press
to select another digit, which will blink.
_ 305.00
To change setpoint 2 value,
press to change the
selected blinking digit value.
300.24 Press (Alarms) again. Meter will reset and display current reading.