Controlled Products Systems Group SG-TB-25-211 - Manual (Page 20)

SG • SG-D Barrier Gate Operator Installation Guide
- 18 -
P1277 Revision X2 8-11-2011
Pay Gate Loop Layout Illustration
2"
3/8"
LOOP SEALANT
USE RELIEF CUTS
AT CORNERS
MULTIPLE TURNS
REFER TO LOOP
INSTALLATION NOTES
FOR DETAILS
TWIST WIRE FROM END OF
LOOPS BACK TO OPERATOR
AT LEAST SIX TIMES PER
FOOT
2" MAX.
WHEN DRIVER INSERTS CARD INTO CARDLOCK, KEY INTO KEYLOCK, ETC., THE GATE ARM WILL RAISE TO ALLOW PASSAGE OF THE VEHICLE. WHEN VEHICLE PASSES OVER AND OFF RESET DETECTOR LOOP, THE GATE ARM WILL LOWER. THIS SYSTEM IS SUITABLE FOR DAILY, MONTHLY, OR PERFERRED PARKING AND IS WIDELY USED BY HOSPITALS, MEDICAL CLINICS, UNIVERSITIES, OFFICE BUILDINGS, FACTORIES, ETC., WHEN THERE IS NEED FOR CONTROLLED PARKING.
OPERATION OF PAY GATE SYSTEM:
PAY GATE LAYOUT
LOCATE BARRIER GATE EQUIPMENT 35' FROM ROADWAY SO THAT APPROCHING VEHICLES ARE ABLE TO COMPLETE RIGHT TURN BEFORE REACHING ACTUATING DEVICE.