Controlled Products Systems Group 8300SL - Manual (Page 22)

20
20 - MAINTENANCE SCHEDULE - APOLLO GATE OPENER
Active the primary (inherent)reverse system by blocking the gate with a solid object. The
gate should reverse momentarily then stop. Restart the gate and block again with a solid
object. The gate should reverse momentarily, then stop, and go into hard shutdown with
an alarm
If operator is equipped with option DC backup system, check to be sure the system
opens the gate upon loss of AC power
If operator is equipped with option DC backup system, check the batteries for any
leakage or loose connections. Batteries should be replaced every two years
Check for alignment, tightness and wear
Check emergency vehicle access device for proper operation
Inspect for damage. Check gate rollers for wear and grease if necessary
Main Sprocket and chain
Check that the gate reverses on contact with an object in both the opening and closing
cycles
Check vehicular reverse and shadow loops for proper operation
Check manual release for proper operation
Overall Check: Complete check of gate and gate operating system
Check screws and nuts
Remove top lid and sweep out any debris or dust that may have accumulated. Every 6
months.
Alarm
Backup System
Battery
Drive Chain
Fire Dept
Gate
Chain lube
Reverse System
Loop(s)
Release
Complete
Mounting Hardware
Rain Drain
COMPLETE
●
●
●
●
●
●
●
●
●
●
●
●
●
BASIC
●
●
●
●
●
Table 2
19 - GLOSSARY
BLOCK"D@RDR@KKNODQ@SNQETMBSHNMDWBDOS'(&'/1(.1(38HMOTSR
COMMERCIAL / GENERAL ACCESS VEHICULAR GATE OPERATOR-
CLASS II - A vehicular gate operator (or system) intended for use in a com-
LDQBH@KKNB@SHNMNQATHKCHMFRTBG@R@LTKSHE@LHKXGNTRHMFTMHSjUDNQLNQD
single family units), hotels, garages, retail store, or other building servicing the
general public.
ENTRAPMENT - The condition when an object is caught or held in a position
that increases the risk of injury.
FORCE STATIC - Constant load threshold for sensitivity setting.
FORCE DYNAMIC - Impact sensitivity setting.
GATE - A moving barrier such as a swinging, sliding, raising, lowering, or the
like, barrier, that is a stand-alone passage barrier or is that portion of a wall
or fence system that controls entrance and/or egress by persons or vehicles
@MCBNLOKDSDRSGDODQHLDSDQNE@CDjMDC@QD@
(STEP H) HIGH PRIORITY - Step by step control
INHERENT ENTRAPMENT SENSOR SYSTEM - An automatic sensor sys-
tem which senses entrapment of a solid object and is incorporated as a per-
manent and integral part of the operator.
INDUSTRIAL / LIMITED ACCESS VEHICULAR GATE OPERATOR-
CLASS III - A vehicular gate operator (or system) intended for use in an
industrial location or building such as a factory or loading dock area or other
locations not intended to service the general public
RESTRICTED ACCESS VEHICULAR GATE OPERATOR-CLASS IV - A
vehicular gate operator (or system) intended for use in a guarded industrial
location or building such as an airport security area or other restricted access
locations not servicing the general public, in which unauthorized access is
prevented via supervision by security personnel.
RESIDENTIAL VEHICULAR GATE OPERATOR-CLASS I - A vehicular
gate operator (or system) intended for use in a home of one-to four single
family dwelling, or garage or parking area associated therewith.
STEP BY STEP - Command that opens-stops-closes-stops the gate with
each press of the button.
SYSTEM - In the context of these requirements, a system refers to a group of
interacting devices intended to perform a common function.
UNBLOCK - Resumes normal operation after a blocked condition.
WIRED CONTROL BNMSQNKHLOKDLDMSDCHM@ENQLNEjWDCOGXRHB@KHMSDQ-
connections between the control, the associated devices, and an operator to
perform predetermined functions in response to input signals.
WIRELESS CONTROL BNMSQNKHLOKDLDMSDCHMLD@MRNSGDQSG@MjWDC
physical interconnections (such as radio waves or infrared beams) between
the control, the associated devices, and an operator to perform predeter-
mined functions in response to input signals.