Controlled Products Systems Group 3500ETL-1K - Manual (Page 7)

7
POST LOCATION GUIDE
1 - 3500ETL-1K/3600ETL-1K POST INSTALLATION DIMENSIONS
Determine the angle that the gate will open to (A). Select the post coordinates (B&C) as shown
on the chart below. Distances are from the hinge square to the center of the mounting post.
Longer gates should operate at the longer speeds.
Figure 1: Overview of Post Location
A
Open Degrees
B
inches
C
inches
D
inches
E
inches
Approximate
Seconds to open
90º 10 31.2 46.3 40.6 15
90º 10 30 47.1 42 16
92º 15 30 42.1 34 15
97º 13.5 25.5 46.3 46.8 17
97º 15 25 45 47.1 16
100º 20 25 40 43.7 13
107º 20 20 42.4 53.5 17
110º 25 20 37.4 50.6 13
116º 25 15 39.3 58.4 16
117º 20 15 44.3 50.3 20
OPTIMUM
Table 1: Table 1: Optional Gate Opening Angles & Post/Arm Measurements