Controlled Products Systems Group 3500ETL-1K - Manual (Page 34)

34
Steps on how to place the Apollo 1050 control board into learning mode.
1. Press Function
2. Press OK
3. Select Swing
4. Select weight of gate (LIGHT , AVERAGE, or HEAVY)
5. Press Enter
Unit should now be in LEARNING MODE
16 - APOLLO 3500ETL-1K PROGRAMMING QUICK START
17 - Putting the controller into learning mode
Learning 3500ETL-1K/3600ETL-1K Actuator
1. Install electrical power to the gate opener unit.
2. Install all gate accessories such as Photo-Eye’s, Sensors, Loops and other safety devices.
3. Turn on the electrical power to the unit.
4. Using the MOTOR DISCONNECT SWITCH, disengage the drive motor. See Figure 19 - MO-
TOR DISCONNECT SWITCH.
5. Move the gate manually (with your hands) to ensure that the gate travels to the fully open and
fully closed positions with no binding or problems. Gate should move freely.
6. Using the MOTOR DISCONNECT SWITCH, re-engage the drive system, re-engage the drive
system, setting the switch to ON (see Figure 19)
7. Using the open button on the front of the Control board, hold the button down until the gate
reaches the fully open position. If the gate moves in the opposite direction swap the RED and
BLACK motor leads at the 3-pin motor power connector on the control board.
8. Adjust the Magnet Collar OPEN on the Limit Assembly (see Figure 16) until the GREEN light
illuminates on the front of the control board. The FULLY OPEN limit switch is now set.
9. Using the CLOSE button on the front of the Control Board, hold the button down until the gate
reaches the fully closed position.
10. Adjust the Magnet Collar CLOSE on the Limit Assembly (see Figure 16) until the RED light
illuminates on the front of the control board. The fully CLOSED limit switch is now set.
11. The control board is already in the “LEARNING MODE” when shipped. If not in LEARNING
MODE, press FUNCTION, then press LEARN, then press SWING, then select LIGHT, AVER-
AGE < or HEAVY, then press ENTER to start the gate learning process.
12. The gate will open partially then stop. This is being done, so that the control board can sense
the type and operational condition of the drive motor. The gate will then run to the closing lim-
it, so that it can properly sense where it is located.
13. The control board will then OPEN the gate slowly to establish travel and limits.
14. Once the gate reaches the fully OPENED limit switch, the control board will now increase
gate travel speed to the highest speed allotted, and will now travel to the fully CLOSED posi-
tion at full speed.
15. The gate opener is now programmed for basic usage.