Table 3, 15 - apollo gate opener troubleshooting table 2, 14 - maintenance schedule - apollo gate opener – Controlled Products Systems Group 3500ETL-1K User Manual
Page 33
33
TABLE 3
SYMPTOM(S) POSSIBLE
SOLUTION
Operator will not pow-
er On.
Power LED is OFF
x
Check terminal Lock wiring for loose or broken wires
x
Check the fuse
x
Check wiring polarity
Gate opens a short
distance, then stops
and reverses
x
Check the UL/Edge input on the gate controller
x
Adjust Force Settings
x
Check Motor 1 and Motor 2 encoder LEDs to verify the LEDs toggle
when the gate is moving
Gate opens but will
not close
x
Check the input LEDs. Any ON will hold the gate open and indicates
a problem with a keying device
x
Check the secondary safety devices. Any activated safety devices
will hold the gate open and indicates a problem with the safety de-
vice
x
Check the loop detectors. Any activated safety devices can hold the
gate open and indicates a problem with the loop detector or ground
Hard Shutdown (2
back to back obstruc-
tions) LED blinking,
Buzzer sounds for 5
x
Clear any obstructions from the path of the gate. Press RESET to
clear (or hard reset button)
Gate opens by itself
x
Check accessory inputs and clear them as necessary
15 - APOLLO GATE OPENER TROUBLESHOOTING
TABLE 2
COMPLETE BASIC
Alarm
Activate the primary (inherent) reverse system by blocking the gate
with a solid object. The gate should reverse momentarily then stop.
Restart the gate and Lock again with a solid object. The gate should
reverse momentarily, then stop, and go into hard shutdown with an
alarm
●
●
Battery
Check the batteries for any leakage or loose connections. Batteries
should be replaced every two years
●
Fire Dept
Check emergency vehicle access device for proper operation
●
●
Gate Inspect
for
damage
●
Reverse Sys-
tem
Check that the gate reverses on contact with an object in both the
opening and closing cycles
●
●
Loop(s) Check
vehicular
reverse
and
shadow loops for proper operation
●
●
Release
Check Motor Disconnect Switch for proper operation
●
Complete
Overall Check: Complete check of gate and gate operating system
●
Mounting Hard- Check screws and nuts
●
14 - MAINTENANCE SCHEDULE - APOLLO GATE OPENER