Controlled Products Systems Group DL650 - Manual (Page 9)

CAUTION! This step will clear the entire entry code memory.
7. Press
Response BEEP! BEEP! 1. Press
NOTE: To add additional entry codes, repeat steps 3 - 7, otherwise continue.
2. Press (or new PAC)
8. Press Then Response BEEP! BEEP!
Response BEEP! BEEP! BEEP! PROGRAM COMPLET E
3. Press
4. Press
Relay Code Function
1 Cycle relay 1 for programmed time 5. Press
2 Cycle relay 2 for programmed time Response BEEP! BEEP!
3 Cycle relay 1 and 2 for programmed time
4 Release relay 1 and 2 6. Press Then
5 Toggle relay 1 (hold open/release relay 1) Response BEEP! BEEP! BEEP! PROGRAM COMPLET E
6 Toggle relay 2 (hold open/release relay 2)
7 Toggle relay 1 and 2 (hold open/release relays 1&2)
Table 1
Time Zone
0 = Off
1 = On
Page 6 Table 2 Page 7
#
0
0 #
# #
0 0 0 0 0
7
#
1 0 1 0 1 0
0 #
#
Relay Control Codes
2