Programming – Controlled Products Systems Group DL650 User Manual
Page 8
1. Press
2. Press
(or new PAC)
Response BEEP! BEEP!
3. Press
4. Press
(Number of Seconds 002 to 240)
PROGRAMMING
The next five pages will explain how to program the system. If you find yourself
5. Press
confused in the middle of a program step, simply remove power from the unit, wait
Response BEEP! BEEP!
4 seconds, re-apply power, start your program step over.
6. Press
Then
Notice that all programming steps begin with entering the PAC:
Response BEEP! BEEP! BEEP!
PROGRAM COMPLET E
And end by exiting the programming mode:
Page 8
Page 5
PROGRAMMING
PROGRAMMING
Erasing Individual Entry Codes
To erase a single entry code:
1. Press
2. Press
(or new PAC)
Response BEEP! BEEP!
1. Press
3. Press
2. Press
(or new PAC)
4. Press
(Entry Code to be deleted)
Response BEEP! BEEP!
5. Press
3. Press
Response BEEP! BEEP!
4. Press
(Entry Code)
6. Press
Then
Response BEEP! BEEP! BEEP!
PROGRAM COMPLETE
5. Press
"Relay Code 1-7". (See Table 1 Below)
6. Press
or
"Time Zone of/off". (See Table 2 Below)
Erasing All Entry Codes
Master Board
The factory setting for entry code length is 4-Digits. If you wish to use 5-Digit codes
go to page 9 and change the length before entering codes for the first time.
The Digital Lock will hold 1 to 650 entry codes depending upon the model purchased.
To verify the memory size refer to the sticker on the memory chip. To enter the
programming mode, a Program Access Code (PAC) must be entered. The factory set
PAC is 000000. To change the PAC refer to the "Program Access Code" section on
page 10. To program an entry code:
Programming Entry Codes
#
0
0
#
#
#
0
0
0
0
0
6
#
#
0
#
#
0
0
0
0
0
5
0
1
#
0
0
#
#
#
0
0
0
0
0
0
2
#
Slave
Light Bulb
Slave Board
(Sold Separately)
12 VAC to Slave Light Bulb only
0
0
0
0
0
0
#
#
#
0
#
Or New Program Access Code (PAC)
2