CognitiveTPG A798 - Manual (Page 38)

Chapter 4: Programming Commands 38 Revision C 12/09
A798-PG00001C
Select cut mode and cut paper
ASCII GS V m GS V m n
Hexadecimal 1D 56 m 1D 56 m n
Decimal 29 86 m 29 86 m n
Value of m: Selects the mode as shown in the table.
Value of n: Determines cutting position only if m is 65 or 66.
m Feed and cut mode
0, 48 Full cut (no extra feed)
1, 49 Partial cut (no extra feed)
65 Feeds paper to cutting position + (n times vertical motion unit), and cuts the paper completely
66 Feeds paper to cutting position + (n times vertical motion unit), and performs a partial cut
Range of m: 0, 48; 1, 49
65, 66 (when used with n)
Range of n: 0 – 255
Default of m, n: 0
Selects a mode for cutting paper and cuts the paper. There are two formats for this command, one requiring one parameter
m, the other requiring two parameters m and n. The format is indicated by the parameter m.
Formulas
n times the vertical motion unit is used to determine the cutting position to which the paper is fed.
Print test form
ASCII US t
Hexadecimal 1F 74
Decimal 31 116
Prints the current printer configuration settings on the receipt.
Disabled in page mode.