CognitiveTPG A798 - Manual (Page 27)

Chapter 3: Programming the Printer 27 Revision C 12/09
A798-PG00001C
Emulation modes
The CognitiveTPG A798 printer may be operated in a number of different emulation modes. However, printing
characteristics and defaults may differ, depending on the desired mode.
Print setup in emulation modes
Refer to the chart below for defaults and allowed printing options in each emulation mode.
Emulation
LPI Font(s) Font Default Default Comments
mode options options size LPI EDR
Native 6.00, 6.77, 7.52, 8.13 Standard 13X24 7.52 3 Default setup for monochrome paper
Tall 13X27 6.77 3
A794, A793 6.00, 7.52, 8.13 Standard 13X24 7.52 3
emulations
LEGACY* 6.00 Tall 13X27 6.00 7 Default setup for LEGACY emulation
emulation Standard 13X24 6.00 10
The following list clarifies how the A798 printer will behave in each emulation mode:
• If only the font is changed, the default LPI will automatically be changed as in the table above.
• If emulation is switched from any emulation to A798 native, the font and LPI will remain unchanged because the A798
native mode supports all font and LPI options offered in the emulation modes.
• The “Set Default LPI” option in the configuration menu is not offered in LEGACY emulation made. The LPI is set at
6.00.