CognitiveTPG A798 - Manual (Page 35)

Chapter 4: Programming Commands 35 Revision C 12/09
A798-PG00001C
Generate tone
ASCII ESC BEL
Hexadecimal 1B 07
Decimal 27 7
Generates an audible tone. Performed by the printer to signal certain conditions.
Related information
This command is ignored in LEGACY emulation.
Select peripheral device (for multi-drop)
ASCII ESC = n
Hexadecimal 1B 3D n
Decimal 27 61 n
Value of n: 0 (bit 0), device not selected
1 (bit 0), device selected
Default: 1 (bit 0), device selected
Selects the device to which the host computer sends data.
Related information
Other bits of n (1–7) are undefined and ignored.
When the printer is disabled by this command, it ignores transmitted data until the printer is re-enabled by the same
command.
Initialize printer
ASCII ESC @
Hexadecimal 1B 40
Decimal 27 64
Default: Character pitch: 15.6 CPI
Column width: 44 characters
Extra dot rows: 3
Character set: Code Page 437
Printing position: Column One
Clears the print line buffer and resets the printer to the default settings for the start-up configuration (refer to Default
settings above).
Single-wide, single-high, non-rotated, and left-aligned characters are set, and user-defined characters or logo graphics are
cleared. (Flash memory is not affected.) Tabs reset to default. Receipt selection state is selected.