Cleveland Motion Controls ULTRA ISC CARTRIDGE TRANSDUCER REV AA - Manual (Page 11)

MAN-70430-0 R EV AA U LTRA S ERIES S TATIONARY S HAFT T RANSDUCER T ECHNICAL M ANUAL
1.5 General Specifications
Item Specification Comments
Input Supply
Power Supply Requirements 21.6-26.4 VDC @ 50mA Basic Isolated Amplifier
Load Cell (Transducer)
Transducer Excitation (Vexc) 3.0 VDC FIXED Internally supplied.
Amplifier
Calibration Range Min. 0.9 - Max. 9 Multi-turn Gain adjustment provided.
Zero Adjustment Output Zero Preset at CMC – Accessible
by user if absolutely necessary 0V=Zero force on beam
Span (Gain) Adjustment Preset at CMC – Accessible by user if
absolutely necessary Adjustments provided
Amplifier Output Signal +/-10 VDC @ 2 mA
+/-10 is undamped signal
Isolation
Isolation +/- 50 V max. output circuit potential not to exceed
50 V from protective earth potential
1.6 Physical Specifications
Item Specification Comments
Enclosure Type
Integrated Signal Conditioning mountable
with special adjustments accessible from
the surface. Remove sticker or screw to
access the setup potentiometers.
Aluminum enclosure just behind the
M12 connector.
Enclosure Size
Base: 26 mm wide by 26 mm high
Length:43 mm 1.0 inches (width) by 1.0 inches
(height) 1.7 inches (depth)
Weight – Basic Amplifier 50 Grams 2.5 ounces
Connector 4 Pin M12 Quick-Connect M12 Quick-Connect 4 Pin, DC Keyed
1.7 Environmental Requirements
Requirement Description
Enclosure
IP50
NEMA 1
Operating temperature
0 to 70 degrees C
32 to 158 degrees F
Humidity
Non-condensing
85% at 55 degrees C
85% at 132 degrees F
Altitude
1000 meters
3300 feet
Atmosphere Non-flammable, non-corrosive and dust free
Storage temperature range
-30 to 90 degrees C
-22 to 194 degrees F
Transport temperature range
-40 to 80 degrees C
-40 to 176 degrees F
3