INSTEON Ballast Dimmer - 2475DA2 Manual - Manual (Page 5)

Page 5 of 16 2475DA2, 2442-422, 2442-522 Rev: 1/21/2014 8:31 AM
Install Ballast Dimmer for Dimmable Ballast
Note: use with branch circuit breakers 15 Amperes or fewer.
1) Write down the INSTEON ID found on the front of the unit (XX.XX.XX)
2) Turn off breaker/fuse and verify that the power is off
3) Disconnect wires from existing switch
4) Connect wires per diagram.
5) At the ballast location, disconnect the wires from the fixture you will be controlling and ensure that you have ½ inch of bare
wire on the ends
6) See the diagram to identify and connect the line, load, neutral DC(+) and DC(-) wires on Ballast Dimmer. Be sure you have
correctly identified the wires in the junction box before connecting them.
7) After ensuring wires are firmly connected and that there is no exposed wire, turn on breaker/fuse
After a few seconds, load will turn on
8) Test Ballast Dimmer connection by tapping set button a couple times
Ballast Dimmer load will respond appropriately
9) Link Ballast Dimmer to your INSTEON keypad or other INSTEON controller. See Make Ballast Dimmer a Responder .
10) Gently place Ballast Dimmer into the fixture box, making sure nothing could accidentally press the set button
11) Reinstall the fixture
12) Use the included INSTEON ID stickers to keep track of the modules location
The hot feeding this circuit is paralleled from the hot connection
on the keypad keeping both devices powered at all times and
using existing wiring.