INSTEON Ballast Dimmer - 2475DA2 Manual - Manual (Page 10)

Page 10 of 16 2475DA2, 2442-422, 2442-522 Rev: 1/21/2014 8:31 AM
Remove Ballast Dimmer as a Controller
If you no longer want Ballast Dimmer to control another device (or are removing Ballast Dimmer) it is important that
you follow the instructions below for each responder.
1) Press and hold Ballast Dimmer set button until it beeps
LED will start blinking green
2) Press and hold Ballast Dimmer set button until it beeps a second time
LED will start blinking red
3) Press and hold responder set button until it double-beeps (or LED blinks)
Ballast Dimmer will double-beep and LED will stop blinking
4) Test by tapping Ballast Dimmer on and off
Responder will not respond
Factory Reset
NOTE: All settings and scenes will be erased
1) Disconnect Ballast Dimmer from power for about 10 seconds
2) While holding down the set button, reconnect power to Ballast Dimmer, making sure not to let go of the set
button
Ballast Dimmer will beep and the status LED will turn on solid green
3) Continue to hold down the set button for 3 seconds and then release
Ballast Dimmer will double-beep and the load will turn on
Restoring Power
Ballast Dimmer stores all of its settings, such as links to other INSTEON devices, with non-volatile memory. Because
settings are saved in this non-volatile memory, they will not be lost in the event of a power failure.
In the event of a power loss Ballast Dimmer will automatically return the load to the state it had before power was
interrupted.