INSTEON ToggleLinc Relay (2466SW) Manual - Manual (Page 14)

Page 14 of 18 Rev: 1/21/2014 7:34 AM
Changing LED Brightness Levels
ToggleLinc Relay’s status LED can be adjusted to shine brighter or dimmer, or even turned off.
1) Press and hold Set button until it beeps.
ToggleLinc’s status LED will blink.
2) Press and hold Set button until it beeps again.
ToggleLinc’s status LED will continue blinking.
3) Press and hold Set button until it beeps a third time.
ToggleLinc’s status LED will stop blinking.
4) Press and hold the toggle up or down to brighten/dim the status LED to the desired level.
5) Once you have reached the desired brightness level, tap Set button.
ToggleLinc will beep.
Factory Reset
Factory Reset clears all user settings from ToggleLinc Relay, including INSTEON scenes, on-levels, ramp
rates, X10 addresses, etc.
1) Pull out ToggleLinc’s Set button to create an air gap.
2) Wait 10 seconds.
3) Push in Set button and hold it. Do not let go.
ToggleLinc will begin to emit a long beep.
4) When beep stops, release Set button.
A few seconds will pass.
ToggleLinc will double-beep.
LEDs will return to normal brightness.
The connected load will turn on.
Additional Resources
Additional Resources
Find home automation solutions, helpful tips, interactive demos, videos, user forums, and more at the
INSTEON Learning Center:
www.smarthome.com/learningcenter.html
Specifications
General
Product Name ToggleLinc Relay
Brand INSTEON
Manufacturer Product Number 2466SW, INSTEON ToggleLinc Relay (Non-Dimming), White
UPC 891114000556
Patent Number
Protected under U.S. and foreign patents (see
www.insteon.com)