Using togglelinc relay, Using the toggle, Using the air gap – INSTEON ToggleLinc Relay (2466SW) Manual User Manual
Page 10: Adding togglelinc relay as an insteon controller, Removing togglelinc relay as an insteon controller

Page 10 of 18 Rev: 1/21/2014 7:34 AM
Using ToggleLinc Relay
Using the Toggle
Like any traditional toggle switch, tapping the switch up turns on the load while down turns it off.
Using the Air Gap
Anytime you need ToggleLinc’s controlled circuit to be unpowered but don’t want to turn off the circuit
breaker—such as when replacing light bulbs—use the air gap to quickly and conveniently disable power
to the switch.
Using your fingernail or a small flathead screwdriver, pull out ToggleLinc’s Set button as far as it will go
(about 1/8”). This opens the mechanical contacts and removes all power from the ToggleLinc and its load.
(Because ToggleLinc’s settings are stored in its non-volatile memory, your setup information will not be
lost.) To re-enable power to ToggleLinc, simply push in the Set button until it is flush with the trim frame.
Programming ToggleLinc Relay as Part of an INSTEON Network
ToggleLinc Relay can be added to an INSTEON network as both a controller and a responder.
Additionally, it can act as an Access Point to detect your home’s electrical phases and allow RF-only and
powerline-only devices to communicate with each other.
Adding ToggleLinc Relay as an INSTEON Controller
Follow the steps below to link ToggleLinc Relay as a controller of another INSTEON device.
1) Press and hold ToggleLinc’s Set button until it beeps (about 3 seconds).
Status LED will blink.
You will have 4 minutes to complete the next steps before linking mode times out.
2) Set the responder to the state you want to activate from ToggleLinc (e.g., on, 50% brightness, off).
If the responder is a multi-scene device such as a KeypadLinc, tap the scene button you want to
control so its LED illuminates.
3) Press and hold the responder’s Set button for 3 seconds.
ToggleLinc will double-beep and its LED will stop blinking
Responder’s LED will stop blinking and it may double-beep.
4) Confirm that linking was successful by tapping ToggleLinc’s toggle on and off.
The responder will respond appropriately.
5) If you want ToggleLinc Relay to control multiple responders, repeat steps 1-4 with each additional
responder or see Add Multiple Scene Responders.
Removing ToggleLinc Relay as an INSTEON Controller
If you are disabling or removing any INSTEON responders that ToggleLinc controls, it is very important
that you unlink each responder from ToggleLinc before disabling or removal. Otherwise, ToggleLinc will
repeatedly try to send commands, causing delays in your INSTEON network’s inter-device
communication.
1) Press and hold ToggleLinc’s Set button until it beeps (about 3 seconds).
Status LED will blink.
2) Again, press and hold ToggleLinc’s Set button until it beeps (about 3 seconds).
Status LED will continue blinking.
You will have 4 minutes to complete the next step before unlinking mode times out.
3) Press and hold the responder’s Set button for 3 seconds.